AUTOMATIC SHUTTER APPROVED FOR CAMPER LPG CYLINDERS 30MB - 1.5KG - CAVAGNA

CAVAGNA - Automatic reverser for 2 LPG cylinders with 30mb regulator, flow rate 1.5Kg/h

EN16129 ANNEX D STANDARD FOR RECREATIONAL VEHICLES

The regulator - exchanger is specially designed to power a gas system on a caravan, camper or fresh water boat, as per the specifications of Annex D of the EN16129 standard. The product automatically switches a two-cylinder gas system to the reserve cylinder when the service cylinder is used up.

The knob changes from green to red when the cylinder is empty.

TECHNICAL INFORMATION

• Butane / Propane
• Flow rate: 1.5 kg/h
• Calibration: 30 mbar
• Entrances: M 20x1.5
• Outlet: with Copper/Steel tube nose cone Ø 8 mm
• Standard: EN16129
• Operating temperature: -20/+50°C

INPUTS:

It connects with 2 GOK or TRUMA hoses with M20X1.5 gas regulator thread. See high pressure hoses category.

If you wish to transform the M 20x1.5 male gas inlets for gas regulators into male connections for W 20 x 1/14 SX Italian cylinders, use two adapters, our code 15805.

EXIT:

Outlet with ogive fitting for connection to 8mm copper or steel pipe.

Compatible with Truma Gas Filters.

• Inlet pressure: 0.7-16 bar
• Regulated pressure: 30 mbar
• Guaranteed output: 1.5 Kg/h
• INPUTS G.13-G.14-G.18-G.23 of EN16129
• OUTPUT: H.7-Hp-H.11-H.19 of EN16129

Extract from the use and maintenance manual

.......

PUTTING “SERVICE” INTO USE

After checking that the indicator remains green in both positions of the knob, rotate the knob so that the arrow points to the right or left. The arrow on the knob will indicate the cylinder in "service" use.

OPERATION OF THE “RESERVE”

The indicator is red, which means the “in service” cylinder has been used up. It is now empty and the installation works on the "reserve" cylinder.

REPLACEMENT OF THE “EMPTY” CYLINDER

Rotate the knob half a turn. The cylinder previously in "reserve" becomes the cylinder in "service", the indicator normally turns green. If it remains red it means that the installation has worked too hard with the cylinder in "reserve" and the latter is also empty. It will therefore be necessary to change both cylinders.

• Close the tap on the empty cylinder. Disconnect the cylinder.
• Connect the full cylinder. Check that the connections are closed correctly and that there are no leaks using a foaming product.
• When the operator check is finished, reposition the arrow on the cylinder previously in use in order to empty it. The new cylinder now constitutes the "reserve" of the installation.

...........

Operating temperature range: -20°C + 50°C

...

It cannot be used in closed rooms as it has an overpressure (vent) device which discharges into the atmosphere when the gas pressure exceeds the set value.

......