ANTARION wired 1 batt controller 110W panel kit

110W ANARION mono crystalline panel kit with charge regulator for 1 battery including assembly components.

Made with monocrystalline silicon cells mounted on an anodized aluminum frame and protected by sturdy, shatterproof tempered glass.

Technical features

Power 110W

Maximum voltage 20.88V

Maximum current 5.44A

Open circuit voltage 24.48V

Short circuit current 5.73AùDimensions 1024x670x60 cm

Weight 7.9kg

Cables 45 m - 2 x 2.5 mm2

Maximum system voltage 1000 V/dc

Cell size 158.75 x 158.75 mm

Cell type Monocrystalline silicon (standard) A grade 182 MONO PERC

Kit composition:

• 1 monocrystalline photovoltaic panel
• 3 fixes riveted panels to the panel
• 1 roof entry with pre-assembled cable gland
• 1 ANARION charge regulator for one battery
• 1 glue cartridge
• 5 m of pre-wired 2x2.5 mm² cable
• 1 bottle 30 ml primer

Assembly instructions

Draw fresh power directly from the battery for each panel.

• Do not use existing circuits or pass through existing devices and/or terminal blocks.

• Do not use existing switches.

• Each power supply must be equipped with a suitable fuse on the “+” line. This fuse should be placed as close to the battery as possible.

How to Glue the Solar Panel

• We recommend using the adhesive supplied with the Kit (if applicable) following these preparation instructions:

• temperature conditions for using the adhesive: between 10 and 25°C
• sand the surfaces to be glued with sandpaper (medium grain).
• clean the surface with a product recommended by the adhesive manufacturer

• Glue the fixing tabs generously to the two ends of the panel, pressing moderately. The thickness of the glue must be +/- 3 mm.

•Drying time: 24 hours.

For optimal performance of the solar panels, it is recommended to periodically keep their surface clean.